Partially of step six, I applied one of the brackets (II) to show FF Considering that the mini screwdriver would not fit involving the shelves. I don't believe this phase can be accomplished away from purchase, so you just really need to make because of. It a bit bent the bracket, but there need to be one added inside the spare elements bag. In any
five. In stage fourteen, when putting in the tracks (DD) to your Wooden blocks (R), contain the wooden block stick out around an inch past the sting on the tracks for the facet that will connect to the top piece (K and The remainder). Another two blocks really should be flush with the tip with the tracks that attach to the cabinet piece.With many m
five. In action fourteen, when installing the tracks (DD) on the wood blocks (R), contain the picket block adhere out somewhere around an inch past the edge on the tracks for your side that could connect to the end piece (K and the rest). One other two blocks must be flush with the end of your tracks that connect to the cabinet piece.I designed the
I made all of them flush initially which induced the tracks to not be extensive more than enough, Therefore the 3rd leaf overlapped the edge of your table by about one particular centimeter. Leaving that additional inch (on the block sticking past the tracks) will enable you to properly lengthen the table, include the 3rd leaf, then force the table
I did not choose to get it apart, so I screwed them on from an angle and added a rubber band below among the list of brackets, so it latched properly. I wish I would've hooked up them in step 13!We haven't obtained chairs yet; on the other hand, I will not know how three chairs could match on each side. My folding chair is eighteen.five inches and